Flash tube

Replacement flash tube for Rollei studio flashes

The modular and particularly maintenance-friendly design of the new one Rollei studio flash HS Freeze also allows components to be exchanged quickly outside of protected studio settings. The independence from stationary power sources and the high-performance battery, which can be replaced in just a few steps, ensure that professional photographers can now choose their locations much more flexibly according to their personal ideas.

The corresponding general conditions on the outdoor set are correspondingly challenging. In order to be able to continue the photo project even if individual elements are damaged, important parts such as the Flash tube of course also separately Stock or spare part available. The High performance flash tube was developed specifically for the HS Freeze and only fits in this lightning innovation.

Our tip: Get several replacement flash tubes to be prepared for all eventualities on your next outdoor or studio set.

Instructions for changing the flash tube

Be sure to switch off the flash before changing the flash tube disconnect the device from the power supply or remove the battery. Wait until the protective bell and flash tube are cold. The flash tube may only be changed if the device (flash capacitors) is discharged!

Important: Under no circumstances should you touch it the exposed electrodes of the flash tube, as the flash capacitors are also included in the event of a fault flash unit switched off and disconnected from the power supply or removed battery, may still be charged and touching it is life-threatening!

Be sure to use clean and dry cotton or rubber gloves when changing. Carefully pull off the protective bell. Wrap that twisted ignition wire from the flash tube holder and carefully pull the bulb out of the device. To insert a new flash tube, Support the legs of the replacement tube without touching the metal contacts and carefully push it into the final position. Then wrap the ignition wire around the flash tube holder again and put the protective bell back on.

Alternatively, you can also get the flash tube from ours Lightning repair service change for a fee.